Autocue DLP USB Scroll Control Bedienungsanleitung PDF herunterladen (Seite 8)

You have three choices for how to configure the scroll speed:

Use Scroll Table: Use a configurable scroll table to define the speed of the scroll.

Use Linear Mapping (recommended): Use a Linear-Mode Multiplier value to define the speed of the

scroll.

Use Logarithmic Mapping: Use a Logarithmic-Mode Multiplier value to define the speed of the scroll.

This allows for much faster scroll speeds than Linear-Mapping.

Centre-Stop Mode: This mode allows you to scroll forward and backwards using only the scroll knob.

The default setting is for centre-stop mode to be disabled. When disabled, End-Stop mode is used. End-

Stop mode allows you to scroll in one direction using the knob. To change directions, press the FWD/REV

button.

Zero Point: Set the middle location in the scroll range for where the scroll will be stopped. Range is 0-

499. Default is 250. Zero Point is used for Centre-Stop mode only.

Zero Region Size: This is the size of the stopped portion of the scroll range. Increase this to make it

easier to stop the scroll. Maximum value is 15.

1 2 3 4 5 6 7 8 9 10 11 12 13

Keine Kommentare

Autocue DLP USB Scroll Control Bedienungsanleitung Seite 8